News & insight

Yes, but only for application‑specific enquiries. Adhesives and embedment designs vary widely, so we can’t publish direct data comparisons between standard and customised products.

Not through our customisation service – but we’d love to guide you through our Create service and create a new solution for you.

Fixing load limits (FLL) remain the same as their standard counterparts. Weld load limits (WLL) and tightening torques may differ. We can provide these on request.

No, not through our customisation service. The B50/S50 designs (diameter, cropped profile, perforation layout, thickness) are fixed.

Use a large round Head when you need greater load distribution – typically with thin, flexible, or low‑strength materials where a standard Head may cause localised bending, imprinting, or failure.

Yes, but only for application‑specific enquiries. Adhesives and embedment designs vary widely, so we can’t publish direct data comparisons between standard and customised products.

Not through our customisation service – but we’d love to guide you through our Create service and create a new solution for you.

Fixing load limits (FLL) remain the same as their standard counterparts. Weld load limits (WLL) and tightening torques may differ. We can provide these on request.

No, not through our customisation service. The B58/S58 designs (diameter, cropped profile, perforation layout, thickness) are fixed.

Use a large square Head when you need to maximise the load distribution – typically with thin, flexible, or low‑strength materials where a standard Head may cause localised bending, imprinting, or failure.